Cherries Switch Plate

A cherry light switch cover with domed cherries on raised stems and leaves, in up to four colors you choose.

The Cherries

Three pairs of cherries hang across the plate on walnut stems, each pair with two raised leaves. The cherries are domed 2.3 mm proud, round like the real fruit, so they catch the light from any angle. All the color is printed into the plate in layers, with nothing painted, stuck on or glued. Coquette and kitchen at once.

Sizes

Single Toggle (shown): 3.50" x 5.02" (89 x 128 mm), about 0.29" (7.3 mm) deep at the highest point.

Each extra switch or outlet adds 1.81" (46 mm) of width, and the height stays the same. The size chart photos show all 32 shapes with their widths.

On rockers, outlets and multi-switch plates, the cherry design is laid out to fit around the openings. If you'd like to see your size before you order, email us and we'll send a picture.

Configurations

32 configurations in the Style menu, all made to order:

• Single Toggle - one classic flip switch
• Single Rocker - one decora / paddle switch
• Single Outlet - one duplex receptacle
• Double, triple and quad toggles, rockers and outlets
• Data port and coaxial plates, and mixed plates like Toggle & Outlet or Rocker x2 & Blank

Not sure which one you need? Send us a photo of your switch and we'll check.

Colors

The Divoire Range: 21 matte colors. Chalk, Sand, Linen, Pumice, Walnut, Ink, Terracotta, Sage, Slate, Heather, Burgundy, Navy, Apricot, Blush, Mint, Sky, Lilac, Seafoam, Marigold, Saffron and Scarlet (see the color chart photo).

Pick four:

• Color - the plate (shown in Chalk)
• Cherry Color - the cherries (shown in Scarlet)
• Leaf Color - the leaves (shown in Sage)
• Stem Color - the stems (shown in Walnut)

The "Where your colors go" photo shows which part each menu colors. For fewer colors, choose "Same as Color" in an accent menu.

A Note on Color

Screens vary, and so does light. The color on your phone or monitor won't be an exact match for the filament, and a matte finish tends to photograph flatter and lighter than it looks in the hand. Please treat the swatches as a close guide. If a particular shade matters, email us before you order and we'll send a daylight photo of the actual spool.

Built to The Real Device

Openings are cut to standard device sizes, gangs sit on the standard 1-13/16" (46 mm) box spacing, and the screw holes fall on the correct spans: 2-3/8" for toggle, 3-13/16" for rocker and a single center screw for outlet. The back is recessed around the device, so the plate sits flush against the wall.

Material

Printed in matte PLA in our studio. Wipe clean with a damp cloth. It suits a normal interior wall. If it's going somewhere that gets genuinely hot, above a radiator or a range or in strong direct sun, email us and we'll print it in PETG instead.

What You Receive

One plate in the configuration and colors you choose. Mounting screws are not included. Reuse the screws from your current plate, or any standard 6-32 wall plate screw.

Made to Order

Every plate is printed for your order in Pennsylvania.

Please Note

These are decorative wall plates. They close the wall box, but they are not tested or listed to UL 514D.