Arch Reed Switch Plate

A 3D printed light switch cover with an arched top and fine vertical flutes, like a reeded tile, finished with a press-fit ring round the switch in a second colour.

How It Works

Two printed pieces: the plate, and a ring that presses into the channel around the switch. Pick one colour for the plate and one for the ring - make the ring the accent, or match them for a single-colour plate. The ring is held by small detents and lifts out at the two notches above and below it, so you can change the look later.

Sizes

Width x height of each plate:

• Single Toggle - 2.97" x 5.78" (75 x 147 mm)
• Single Rocker - 3.44" x 5.62" (87 x 143 mm)
• Single Outlet - 3.47" x 5.61" (88 x 143 mm)
• Double Toggle - 4.78" x 5.90" (121 x 150 mm)
• Double Rocker - 5.25" x 5.80" (133 x 147 mm)

Each extra switch or outlet adds 1.81" (46 mm) of width.

About 0.32" (8.1 mm) deep. Every plate reaches at least 2.4" (62 mm) above and below the switch, so it covers a standard wall-box cutout.

Configurations

32 configurations in the Style menu, all made to order:

• Single Toggle - one classic flip switch
• Single Rocker - one decora / paddle switch
• Single Outlet - one duplex receptacle
• Double Toggle - two flip switches side by side
• Double Rocker - two paddle switches side by side
• Double Outlet, plus triple and quad toggles, rockers and outlets
• Data port and coaxial plates, and mixed plates like Toggle & Outlet or Rocker x2 & Blank

Need a different layout? Email us - more configurations are on the way.

Colors

The Divoire Range - 21 matte colours: Chalk, Sand, Linen, Pumice, Walnut, Ink, Terracotta, Sage, Slate, Heather, Burgundy, Navy, Apricot, Blush, Mint, Sky, Lilac, Seafoam, Marigold, Saffron and Scarlet.

Choose the plate colour in the Color menu and the ring colour in the Ring Color menu below it.

A Note on Color

Screens vary, and so does light. The colour you see on your phone or monitor will not be an exact match for the filament, and a matte finish in particular tends to photograph flatter and lighter than it looks in the hand. Please treat the swatches as a close guide rather than an exact match. If a particular shade matters, email us before you order and we will send a photo of the actual spool in daylight.

Built to The Real Device

Drawn to the actual hardware rather than eyeballed. Openings are cut to standard device dimensions, gangs sit on the standard 1-13/16" (46.04 mm) box pitch, and the screw holes fall on the correct spans: 3-13/16" for rocker, 2-3/8" for toggle, and a single centre screw for outlet.

Material

Printed in matte PLA - a low-sheen finish that reads like cast plaster or glazed ceramic rather than plastic, with a flat back so the plate sits true against the wall. Matte PLA suits a normal interior wall; if the plate is going somewhere that gets genuinely hot - above a radiator or a range, or in strong direct sun - email us and we will print it in PETG instead.

What You Receive

One plate and one ring in the configuration and colours you choose. Mounting screws are not included - reuse the screws from your existing plate, or any standard 6-32 wall plate screw.

Made to Order

Each plate is printed for your order in Pennsylvania.

Please Note

These are decorative wall plates. They close the wall box, but they are not tested or listed to UL 514D.